HTX-252 MANUAL PDF

FYI, If you decide to attempt any modifications to your HTX, you are doing so at your own risk. HTX Owners Manual HTX/Albrecht AE Service. Update*** I’m still doing this repair for those who may need it. Here are the specifics. I charge a flat fee of $35 which includes the new mic cord, the. Cat. No. OWNER’S MANUAL HTX TWO-METER MOBILE TRANSCEIVER Please read before using this transceiver. INTRODUCTION Your .

Author: Dajas Vudobar
Country: Iran
Language: English (Spanish)
Genre: Travel
Published (Last): 17 September 2015
Pages: 241
PDF File Size: 7.48 Mb
ePub File Size: 8.31 Mb
ISBN: 810-3-29123-502-8
Downloads: 70785
Price: Free* [*Free Regsitration Required]
Uploader: Gokree

Follow these steps to use the transceiver as a base station. To switch between the two htd-252 levels, press LOW. The HTX displays St and the current frequency step.

Radio Shack HTX-252 Owner’s Manual

Important notes in hts-252 manual have a large exclamation mark! I was beginning to think I had lost that little mic. If the fuse frequently blows, there is a problem with the HTX or its wiring.

Press T-SQL a third time to turn off both subaudible tone transmit and squelch. Clearing a Memory Channel You can clear any memory channel except Memory Channel 1 and the calling-frequency memory. Hx-252 show me this message again.

Better htx-52 40 dB. I settled for this one which can be purchased on ebay for around 15 bucks and free shipping. You can also store oth- er settings for each memory location, such as the repeater offset and the CTCSS tones.

To turn the transceiver off, rotate counterclockwise until it clicks. You might need to connect the red wire directly to the battery if you experience manuaal noise. It offers some of the most advanced, and most requested, features available in a mobile transceiver.

  EFFECTIVE COMMUNICATION URMILA RAI PDF

Rotate TUNE or press memory. This procedure clears all stored information. Then slowly rotate clockwise just until the noise stops.

Index of /k/kb1uif/downloads/Service & User Manuals/Radio Shack/HTX

If you saved a re- peater offset in a memory, that setting is not affected. The HTX displays tF and the transmit frequency.

They fit perfectly in the Radio Shack station that I have. Paypal, Cash, or Check are accepted as payment. Using Group Calling Group calling lets you page several users at once. Then while holding downturn on the transceiver. Setting the Subaudible Tones.

Follow these steps to turn on auto-reply. Page 29 Subaudible Tone Frequencies Hz You can also set your HTX to limit reception to only those transmissions that include the selected tone.

manuql

Index of /k/kb1uif/downloads/Service & User Manuals/Radio Shack/HTX-252

The HTX displays rC and the currently set receive tone. Overriding the Duplex Offset When you tune hhtx-252 a frequency, the HTX automatically selects manjal simplex operation, or duplex operation with the correct offset direction if the auto duplex option is on. To store the frequency in the calling-frequency memory, press and hold F for at least 1 second. I also recommend using a flux to help in flowing the solder. Hold down the ribbed transmit button on the side of the microphone, then speak slowly and clearly into the micro- phone.

When it detects a transmission, it checks all memories to see if that frequency is already stored.

The HTX can even scan a selected range and automatically store active htx252 in unused memory locations. Repeater Operation Operation through a repeater, where nanual transmit on one frequency and receive on another, is called duplex operation. You can also limit incoming reception by setting the HTX to open the squelch only when someone transmits a subaudible tone you select.

  LAS BOLUDAS DALMIRO SAENZ PDF

Better than —65dB Deviation Setting the Scan Resume Delay When you set the scan resume condition to cr carrierthe HTX resumes scanning after the carrier drops.

Repeater antennas are typically at the tops of tall buildings or on antenna towers, so a relatively lowpower signal can reach the repeater. I love that radio! For the calling-frequency memory, press and hold F for one second.

Snap open the in-line fuse holder. FUNC — indicates the keypad is locked. Be sure LOCK is not on the display. You can set your HTX to include any of these tones with your transmissions. Flashes when there is a transmission on Memory Channel 1 and the alarm is turned on.

Until it hears the sequence, the HTX does not pass any transmissions to the speaker. Turning Auto Duplex On and Off. Page 40 Limited One-Year Warranty This product is warranted by RadioShack against manufacturing defects in material and workmanship under normal use for one 1 year from the date of purchase from RadioShack company-owned stores and authorized Ra- dioShack franchisees and dealers.